Machinist’s Tool Chest – 3

Thurs. 10th Feb –
This morning I set up the table saw to machine edge bevels on the glued up raised panels for the front and back assemblies. I applied a good coat of tung oil to the panels then after lunch. Then moved on to routing the tenons on the stiles and mutins for them. Next the fitting and sanding and it was 4pm before I had everything ready for the glue up.
Tomorrow I’ll work on the carcase which will have 3/8″ finger jointed corners with mortises to be cut to house the front and back panels.

Leave a Reply

Your email address will not be published. Required fields are marked *